Mount the Repellers

Depending on your installation and selected hardware, follow the appropriate step below to attach a repeller.

Standard Mount - To Install Directly to a Firm Surface

Hold the mount in place and mark the hole locations. Pre-drill at least two holes and attach the standard mount with deck screws (not included). Pass the cable through the cutouts and install the repeller onto the standard mount by squeezing the quick-connect tabs.

Ground Stake - For Soft Ground Like Grass or AMulch

To install, press the stake into the ground until it is flush or just above ground level. Twist on the standard mount. Pass the cable through the cutouts, and attach the repeller by squeezing the quick-connect tabs.

Hardscape Base - For Stone, Pavers, Decking, or Other Hard Surfaces Where Drilling is Not Desired

To install, thread the Standard Mount to the hardscape base until secure. Pass the cables from the repeller through the center of the base and install the repeller by squeezing the quick-connect tabs. Route the cables through the underside of the Hardscape Base so they sit in the cutouts.

Side Mount - For Vertical Hard Services Where Drilling is Ok

To Install, place the Side Mount in the desired location and mark the hole locations. Pre-drill two holes, attach the Side Mount with appropriate screws, and twist on the Standard Mount. Pass the cable through the cutouts and install the Repeller onto the Side Mount by squeezing the quick-connect tabs. Secure the cables with a zip tie.